Motion
Alert Alarm - Infrared Motion Detector
A passive infrared system that will detect movement in any selected 40
ft. area, 105 db Alarm. Complete with programmable security code, adjustable
sensor head, low battery indicator.
This Motion Alarm can be coded with a personal security code and can be
set to utilize a two-tone entry chime, instead of the alarm sound. Mounting
screws and AC connector included. 9-volt battery not included.
Unique passive infrared system concentrates on the protected area you
select. The motion detector alarm studies the area and responds with a
105 db alarm only when a person moves into the protected area.
Compact and attractive, it mounts easily (vertically or horizontally)
near any entry area and is battery operated, eliminating any need for
wiring. Unit can be coded with a personal security code and can be set
to utilize a two-tone entry chime, instead of the alarm sound. Mounting
screws and AC connector included.
Uses 9-volt battery not included.
* Features Motion sensor detects motion and activates alarm.
* Programmable security code and entry delay timing.
* Built-in high output 105db alarm.
* Alarm/door chime option.
* Panic Button triggers alarm immediately.
* Program and low battery indicator.
* Verification tone for key pad and arm/disarm.
* 9V battery operated (battery not included) and AC adaptor compatible.
* 110 degree operating range out to 40 feet.
* 6.5" tall
* 3.25" wide
* 2" deep
* Weight 0.5 lb
There is a 60 second delay after arming for sensor warm up and exit delay.
When activated, the alarm cycles twice with 30 or 60 second rest in between.
The duration of the alarm can be programmed for 30 seconds, 60 seconds,
or 90 seconds. Re-entry Delay can be programmed to prevent alarm from
going off for 15 seconds, 8 seconds, or zero seconds giving you time to
disarm the unit.
* Installation Wall mountable with included screws and screw anchors.
Recommended height is between 3 to 6.5 feet (1 to 2 meters) above floor
for best coverage of protection area.
* Detection head can be flipped up for use as a shelf mounted alarm. No
need to permanently mount in place. Allows you to move unit from one location
to another.
Intrusion Memory Indicator - Motion detector alarm "remembers"
if someone has set off the alarm. When you disarm the unit, if the LED
flashes 3 times, it indicates that there has been an intrusion during
the last arming mode. Be sure to check your home/office thoroughly after
entering.
Noise is any intruders worst nightmare, especially when it is loud and
piercing. People tend to get confused when startled by very loud piercing
noise, and the first
animal instinct of a home intruder is to run for cover. What makes this
motion alert alarm all the more better is its effectiveness and ease of
use.It sets up in minutes. This is "a must-have!" home security
device.
Discount personal alarm
|