DVREye Wireless Multi-Sensor Surveillance System

DVREye™ Wireless RF System combines our DVREye™ with our powerful PixController wireless receiver unit. The above photo shows the interior of the Wireless RF system without the 12V battery and Neuros DVR unit, however, these items are included in the system package.

This DVREye™ Wireless Sensor System video recording system works in conjunction with the Wireless PIR motion sensor. The Wireless PIR motion sensor will transmit a wireless command signal to the DVREye™ Wireless Sensor System when an event is detected. Multiple Wireless PIR motion sensors can control one or more DVREye™ Wireless Sensor System from a distance of 70 feet or greater depending on the terrain and obstructions. Since the DVREye™ Wireless Sensor System is triggered by a wireless digital signal sensor signals can be passed through obstructions such as walls making this a very powerful remote security system.

By removing the PIR motion sensor from within the recording device this will allow for more covert, larger PIR area of detection using several wireless motion sensor, and allow several different types of recording devices used in one setup. You can also increase your sensing area by using multiple Wireless PIR sensors to trigger the camera.

This small wireless PIR motion sensor sends a digital RF signal back to the camera unit for triggering recording. The recording unit "listens" for wireless commands sent from the wireless PIR motion sensor when the motion sensor is tripped. When the recording unit receives a trigger event it will trigger the attached camera system to take a photo or record video.

The wireless RF motion sensor is powered by two small AAA batteries. These batteries will which will last for a year of continuous use. Since the sensor is on all of the time these batteries should be removed for storage.

There are (8) different digital addresses the wireless RF motion sensor can be programmed to send (addresses A – H). By changing the address this gives the user the ability to configure several sensors or recording units within range of each other to respond for a given setup.

Typical Field Setup
A typical video trail/game camera setup is shown below. This system is using multiple RF Wireless PIR motion sensor to cover a wide sensing area. If any of the wireless motion sensors are triggered they will send a wireless command back to the DVREye™ Wireless RF System to start recording. The DVREye™ Wireless RF System can be configured to record as long a motion is present or for a defined amount of recording time. Since the sensors are mounted remotely your DVREye™ Wireless RF System can be hidden or placed in an elevated location.